Setup GPRS on a Comcore DLMS meter (MeterTalk) so it connects to pnpscada
sdg.lesego
2026-08-27 15:45
Overview
The following sets the meter to dial out to PNPSCADA server over GPRS
1, Set the primary address to 1
In the communication parameters, set the primary address to 1. This is the management client, If you leave it on 16 you will be able to read but GPRS write will fail.
2, Set up the GPRS parameters
1, Tick GPRS in the ReadWrite tree on the left.
2, Set work mode to client(01) so the meter connects out to you.
3, Fill in the client block, Primary APN (Your SIM?s APN), Primary TCP-IP Port and Primary Server IP Address(your server?s public IP)
4, Click on Write to write the settings to the meter, then click on Read to verify if the write was successful.
Tags: comcore
Please log in to post a comment